Vintage Karting Forum › Main forums › General v
Need a bit of machining

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Threaded Mode
Need a bit of machining
ted johnson Offline
Arizona City, AZ
*****
Posts: 1,257
Threads: 100
Joined: Jan 2016
Reputation: 18
Location: Arizona City, AZ
#1
07-02-2018, 10:14 AM (This post was last modified: 07-02-2018, 10:35 AM by ted johnson.)
Looking for someone to make a simple seal installation bullet. Joel and Tom K. are away from home, and Mike B. is swamped. Only need one to share with the other Dyna Drive guys who are running the clutch housing Ron C. and I designed. If you're interested, I have my PDF all drawn up. Please PM me. Thanks. Ted
Find
Reply
Brad Emery Offline
Junior Member
**
Posts: 2
Threads: 1
Joined: Nov 2017
Reputation: 0
#2
07-03-2018, 07:24 AM
(07-02-2018, 10:14 AM)ted johnson Wrote: Looking for someone to make a simple seal installation bullet. Joel and Tom K. are away from home, and Mike B. is swamped. Only need one to share with the other Dyna Drive guys who are running the clutch housing Ron C. and I designed. If you're interested, I have my PDF all drawn up. Please PM me. Thanks. Ted

 Check PM
Find
Reply
ted johnson Offline
Arizona City, AZ
*****
Posts: 1,257
Threads: 100
Joined: Jan 2016
Reputation: 18
Location: Arizona City, AZ
#3
07-03-2018, 08:02 AM
Hi, Brad. I sent you a PM with my email address. Thanks! Ted
Find
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)