+- Vintage Karting Forum (https://www.vintagekartforum.com)
+-- Forum: Main forums (https://www.vintagekartforum.com/forumdisplay.php?fid=1)
+--- Forum: General (https://www.vintagekartforum.com/forumdisplay.php?fid=2)
+--- Thread: Need a bit of machining (/showthread.php?tid=2286)
Need a bit of machining - ted johnson - 07-02-2018
Looking for someone to make a simple seal installation bullet. Joel and Tom K. are away from home, and Mike B. is swamped. Only need one to share with the other Dyna Drive guys who are running the clutch housing Ron C. and I designed. If you're interested, I have my PDF all drawn up. Please PM me. Thanks. Ted
RE: Need a bit of machining - Brad Emery - 07-03-2018
(07-02-2018, 10:14 AM)ted johnson Wrote: Looking for someone to make a simple seal installation bullet. Joel and Tom K. are away from home, and Mike B. is swamped. Only need one to share with the other Dyna Drive guys who are running the clutch housing Ron C. and I designed. If you're interested, I have my PDF all drawn up. Please PM me. Thanks. Ted
Check PM
RE: Need a bit of machining - ted johnson - 07-03-2018
Hi, Brad. I sent you a PM with my email address. Thanks! Ted