Vintage Karting Forum

Vintage Karting Forum > Main forums > General > Need a bit of machining
Full Version: Need a bit of machining
You're currently viewing a stripped down version of our content. View the full version with proper formatting.

ted johnson

07-02-2018, 10:14 AM
Looking for someone to make a simple seal installation bullet. Joel and Tom K. are away from home, and Mike B. is swamped. Only need one to share with the other Dyna Drive guys who are running the clutch housing Ron C. and I designed. If you're interested, I have my PDF all drawn up. Please PM me. Thanks. Ted

Brad Emery

07-03-2018, 07:24 AM
(07-02-2018, 10:14 AM)ted johnson Wrote: [ -> ]Looking for someone to make a simple seal installation bullet. Joel and Tom K. are away from home, and Mike B. is swamped. Only need one to share with the other Dyna Drive guys who are running the clutch housing Ron C. and I designed. If you're interested, I have my PDF all drawn up. Please PM me. Thanks. Ted

 Check PM

ted johnson

07-03-2018, 08:02 AM
Hi, Brad. I sent you a PM with my email address. Thanks! Ted
Vintage Karting Forum > Main forums > General > Need a bit of machining