07-11-2018, 07:00 PM
(This post was last modified: 07-11-2018, 07:08 PM by ted johnson.)
(07-11-2018, 04:46 PM)Michael Burke Wrote: ARP has already done the engineering to make the bolt we need. Unfortunately since they found that they didn't already have the tooling and material for 10-32 threads the cost went up to a little over $20 per bolt in a 1000 bolt production run. I worked with them for a couple of months off and on since I live about 1 mile from their plant and I know a member of their staff. If enough people want to put together an order they will make the bolts. I didn't pursue it further because I was told no one would pay that much and then everyone seemed willing to pay the same price for the new bolts that apparently are having some initial problems. I wasn't going to be selling bolts. All I was doing was trying to get them made.Hi, Michael. I know that ARP has the facilities and the engineering skill to make these screws, to properly roll the threads and to heat treat them. Are they talking Mac-length or West Bend length? Are they talking that Multiphase MP159 alloy that was used on Dave B.'s screws? It's a pretty exotic alloy with some nifty components like nickel, cobalt and chromium. I see that there are several suppliers who sell the bar stock. I will bet it isn't cheap. Ted
https://www.aircraftmaterials.com/data/n...mp159.html