03-14-2016, 09:22 PM
Just got most of the jig table set up. I used a lunch table top out of a local factory for the table.
Bolted down the angle iron, level and square so far.
Steve W., your videos helped me a lot, as I'm new to this. Thank you.
I think I'm going to buy a bender - JD3 is what I'm looking at. Not sure what size CLR die I need, a 3.5 or a 4.5.
All advice would be appreciated.
Rick
Bolted down the angle iron, level and square so far.
Steve W., your videos helped me a lot, as I'm new to this. Thank you.
I think I'm going to buy a bender - JD3 is what I'm looking at. Not sure what size CLR die I need, a 3.5 or a 4.5.
All advice would be appreciated.
Rick