05-30-2020, 07:27 AM
(05-29-2020, 11:52 AM)steve welte Wrote: I studied that. You could run a 3/4 hub and turn down the end to accept the drum. The drilled hole would only go into 1/2 or the bearing surface. The other half would be sitting on solid shaft so I don't see where it wouldn't work. Problem being for Duals is the class calls of use of oil clutches. Good luck finding much of anything. singles it could be done.
Steve,
The old Burco hub for the straight Yamaha clutches is close to 3/4". I have one and also a straight shaft WB crank if you want to play with it.It would be a outboard drive of course. Got to be some of those old Burcos out there.