03-23-2020, 07:46 AM
I was able to tap out the seal on the left side by tapping the end of the axle on the right with a board and hammer. Once I got the seal off I used a 3/4 inch open end wrench behind the bearing and it started to move and slide off. Then I was able to slide the whole axle out and remove the right bearing which was the stubborn one. I was actually surprised how good of shape the axle is in. The bearings I think are good to reuse but the seals are shot. I looked up the number but had no luck. I’m sure I should be able to find new seals.