11-26-2019, 07:16 PM
(This post was last modified: 11-30-2019, 05:00 AM by Terry Bentley.)
I have not seen anything related to using a Walbro from a KT100 on macs. When set up properly they sure do function well. At least on the piston ports I have run in the past. After drilling out the low speed circuit, these carbs are really easy to tune. At least from my experience. Since I have boxes full of them, thought might find out what they can do.
Bolt pattern is the same, but I want to add the aluminum adapter like used on Yamaha. I plan to use it with a stock intake manifold for small carb. The adapter will be a copy, but drilled to fit the manifold, instead of the smaller bolt pattern of phenolic space This will also index Walbro at the same angle as Yamaha. Then stock throttle linkage can be used.
With this adapter bolted to stock intake, I will run a tapered reamer down the hole big enough to fit a Go-Power 6 pedal reed cage or similar. I have the parts sitting around and the cost is zero, so why not? The mac will be nine ported, so no problems that I see.
Yes I will need to add a place for the pulse tube, but not an issue. Any thoughts?
Bolt pattern is the same, but I want to add the aluminum adapter like used on Yamaha. I plan to use it with a stock intake manifold for small carb. The adapter will be a copy, but drilled to fit the manifold, instead of the smaller bolt pattern of phenolic space This will also index Walbro at the same angle as Yamaha. Then stock throttle linkage can be used.
With this adapter bolted to stock intake, I will run a tapered reamer down the hole big enough to fit a Go-Power 6 pedal reed cage or similar. I have the parts sitting around and the cost is zero, so why not? The mac will be nine ported, so no problems that I see.
Yes I will need to add a place for the pulse tube, but not an issue. Any thoughts?