09-05-2017, 10:44 PM
just send them to terry and don't waste your time trying to find someone local.
he does them at about 80 bux per matches piston to bore.
he has a dedicated lathe jig set up for the bores and produces work hard to match anywhere.
if you are using a saw with a full piston skirt switching to a partial skirt as found on mc91's usually won't work.
biggest issue is the pin to crown height is different if i remember correctly.
i could be wrong the best way to tell is measure the piston from saw then measure piston you are thinking of using.
he does them at about 80 bux per matches piston to bore.
he has a dedicated lathe jig set up for the bores and produces work hard to match anywhere.
if you are using a saw with a full piston skirt switching to a partial skirt as found on mc91's usually won't work.
biggest issue is the pin to crown height is different if i remember correctly.
i could be wrong the best way to tell is measure the piston from saw then measure piston you are thinking of using.
Dave L.