Vintage Karting Forum › Main forums › General v
Wheel spacer question

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Wheel spacer question
stan wauthier Offline
Junior Member
**
Posts: 23
Threads: 0
Joined: Apr 2017
Reputation: 0
Location: Strongsville, OH
#4
06-14-2017, 07:14 AM
Ted,

I used JB weld on mine about 6 or 7 years ago and they are holding up just fine. I built it up some in the inside so there was good coverage, not just the thickness of the half hole.

Stan
Find
Reply


Messages In This Thread
Wheel spacer question - by ted johnson - 06-13-2017, 05:07 PM
RE: Wheel spacer question - by Randy Dacus - 06-13-2017, 06:35 PM
RE: Wheel spacer question - by ted johnson - 06-13-2017, 07:12 PM
RE: Wheel spacer question - by stan wauthier - 06-14-2017, 07:14 AM
RE: Wheel spacer question - by ted johnson - 06-14-2017, 07:25 AM
RE: Wheel spacer question - by stan wauthier - 06-14-2017, 08:25 AM
RE: Wheel spacer question - by ted johnson - 06-14-2017, 08:56 AM
RE: Wheel spacer question - by Jim Waltz - 06-15-2017, 09:57 AM
RE: Wheel spacer question - by ted johnson - 06-15-2017, 10:52 AM
RE: Wheel spacer question - by Jim Waltz - 06-16-2017, 11:48 AM
RE: Wheel spacer question - by ted johnson - 06-16-2017, 01:09 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)