06-13-2017, 06:35 PM
Ted I would tig braze up the part you aren't going to use instead of JB weld or if you don't have tig, there is
that aluma-weld alloy that you can use with a low heat burner that works well with die-cast parts....it's all
about the prep for good results.
Are you going to water-jet some new spacers for the CT wheels ?
If those CT's are some mystery mag material.....you better find a pro to do this for you or just use what you know
will not make a mess of your wheels .
So much for advice, I have some Go Powers that are in need of restoration....so I was just going to find some rear outer wheel half's, but finding them is not so easy......so back to welding and lathe work.....all I need is a " round to-it " !
that aluma-weld alloy that you can use with a low heat burner that works well with die-cast parts....it's all
about the prep for good results.
Are you going to water-jet some new spacers for the CT wheels ?
If those CT's are some mystery mag material.....you better find a pro to do this for you or just use what you know
will not make a mess of your wheels .
So much for advice, I have some Go Powers that are in need of restoration....so I was just going to find some rear outer wheel half's, but finding them is not so easy......so back to welding and lathe work.....all I need is a " round to-it " !