03-23-2017, 06:18 PM
Puller is recommended. A metal bar with three holes. Center hole for screw to crank, two outer screw hole to screw into the small threaded flywheel holes. Apply Allen wrench through cover to hold flywheel from rotating. Watch your fingers.
There is another way, but I don't recommend it.
Here is video. This was the way I did it as a kid. I would try a deadhead hammer if you have one first to see if that will do it. If not, you can try the ball-peen hammer. Make sure the nut is above the crank so it is not exposed.
https://www.youtube.com/watch?v=398s-FFaZLw
There is another way, but I don't recommend it.
Here is video. This was the way I did it as a kid. I would try a deadhead hammer if you have one first to see if that will do it. If not, you can try the ball-peen hammer. Make sure the nut is above the crank so it is not exposed.
https://www.youtube.com/watch?v=398s-FFaZLw