Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
(How Too's) interference fit bearing installation Chance to Rebuild forum
#8
Ted,

Understood on the oven. :-)

fwiw: I bought a gas wall oven that was near brand new at a Goodwill store for $50 about 15+ years ago. I made a little roll-around cart that holds a 5-gallon propane bottle underneath, re-valved the oven for propane, and have been using it all those years. It was a very inexpensive solution for my shop, and had years where it would run all day every day at 350°F. My only concern with the toaster ovens I've used is that some models don't have really good temperature control, and I like being very careful to never go over 350°F on anything made out of aluminum.

PM
Reply


Messages In This Thread
RE: Chance to Rebuild forum "How Too's) - by precisionmetal - 02-07-2017, 11:57 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)