12-03-2018, 07:03 PM
(This post was last modified: 12-03-2018, 07:04 PM by Gary Wlodarsky.)
(12-03-2018, 03:13 PM)Jim Donovan Wrote: The question I have, what is the third bearing bore? Is it supporting the cap screw head which is .550 so a 14mm bearing would nicely support the cap screw or it supporting a longer bolt that the cap screw is going into? I have seen them made both ways.
Jim...
I think the ones that you see ""supporting"" the cap screw is just a screw up...it doesn't really fit tight enough to support the crank,,,,,
in other words..they are using the wrong stuff for it to work correctly...yeah it will keep the broken clutch/crank in place....maybe...
gw