11-22-2018, 10:32 AM
if it's a base mount in theory yes but you'll probably need to modify it.
third bearings support the end of the crank .
they usually are provided with generous adjustment slots.
so the outside plate
kt100 has different bolt pattern from mcculloch so not a direct bolt on.
with a little effort it can be done.
but unless it's free or really cheap it isn't worth the extra work.
unless you have an accurate template the extra work involved could take a couple of hours.
third bearing supports for mccullochs are available brand new from several sources , something i couldn't have said even four years ago.
they average around 80 bux not really that expensive when you consider the time factors.
hope this helps
dave l
third bearings support the end of the crank .
they usually are provided with generous adjustment slots.
so the outside plate
kt100 has different bolt pattern from mcculloch so not a direct bolt on.
with a little effort it can be done.
but unless it's free or really cheap it isn't worth the extra work.
unless you have an accurate template the extra work involved could take a couple of hours.
third bearing supports for mccullochs are available brand new from several sources , something i couldn't have said even four years ago.
they average around 80 bux not really that expensive when you consider the time factors.
hope this helps
dave l
Dave L.