|
Rear axles
|
08-05-2018, 08:23 AM
(08-03-2018, 09:15 PM)ted johnson Wrote: Yes, Brad. I had a machine shop in Albuquerque do one for me, but there's nobody near here I would trust. Don Axe will make me a good one of TG&P stock. Ted I bought one of the Azuza flex proof axles and it was really bent bad. I contacted them and they made it right and sent me another at no charge that was really straight. I'm still using and abusing it today with no issues. |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Rear axles - by ted johnson - 08-02-2018, 06:01 PM
RE: Rear axles - by Kurt Bogerman - 08-02-2018, 06:26 PM
RE: Rear axles - by ted johnson - 08-02-2018, 08:04 PM
RE: Rear axles - by Scott Kneisel - 08-02-2018, 09:11 PM
RE: Rear axles - by Gary Wlodarsky - 08-03-2018, 07:23 AM
RE: Rear axles - by Kurt Bogerman - 08-02-2018, 09:29 PM
RE: Rear axles - by ted johnson - 08-03-2018, 08:10 AM
RE: Rear axles - by ted johnson - 08-03-2018, 11:00 AM
RE: Rear axles - by Brad Rose - 08-03-2018, 08:41 PM
RE: Rear axles - by ted johnson - 08-03-2018, 09:15 PM
RE: Rear axles - by tom dandes - 08-05-2018, 08:23 AM
RE: Rear axles - by Bill Peck - 08-07-2018, 03:55 PM
RE: Rear axles - by Tom Smith - 08-08-2018, 12:14 AM
RE: Rear axles - by ted johnson - 08-08-2018, 08:10 AM
RE: Rear axles - by doug tenney - 08-08-2018, 08:22 PM
RE: Rear axles - by ted johnson - 08-08-2018, 09:10 PM
RE: Rear axles - by doug tenney - 08-11-2018, 11:43 AM
|
