07-17-2018, 08:54 PM
The machinist (before he retired) who did the prep work on my drag car engines would NEVER quench any material he had cut on, ground on, or in any way generated heat. He was insistent the quenching was to quick and too isolated. His solution was to use an air gun in the compressor hose. Same with welded components.......compressed air until you could
touch the mat'l with an unprotected hand for 10 seconds. Seems like it worked for me. Anyone?
Chuck
touch the mat'l with an unprotected hand for 10 seconds. Seems like it worked for me. Anyone?
Chuck