Vintage Karting Forum › Main forums › General v
Correct Sprocket Size

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Correct Sprocket Size
Brian Smith Offline
Junior Member
**
Posts: 39
Threads: 12
Joined: Dec 2017
Reputation: 0
Location: Detroit
#5
01-21-2018, 07:18 PM
Thanks for the knowledgeable advice. I'm roughly 185, soon to be 180 if I stick to my New Years resolution... Just started stripping the kart down today and cutting all of the "extras" off that were welded on over the years. Looks like the brake drum hub is identical to the sprocket hub. Looking at pictures online, it would seem that the LH sprocket is sandwiched between the hub and drum. My Kart appears to have a wider rear axle than others I've seen, and is running 6 Inch tri star Azusa wheels in back. Will post pics later this week of the progress assuming I make some.
Find
Reply


Messages In This Thread
Correct Sprocket Size - by Brian Smith - 01-20-2018, 11:30 AM
RE: Correct Sprocket Size - by steve miller - 01-20-2018, 12:49 PM
RE: Correct Sprocket Size - by doug tenney - 01-21-2018, 03:22 AM
RE: Correct Sprocket Size - by ted johnson - 01-21-2018, 08:45 AM
RE: Correct Sprocket Size - by Brian Smith - 01-21-2018, 07:18 PM
RE: Correct Sprocket Size - by steve miller - 01-21-2018, 08:51 PM
RE: Correct Sprocket Size - by Tom Smith - 01-22-2018, 03:10 AM
RE: Correct Sprocket Size - by Randy Dacus - 01-22-2018, 03:46 AM
RE: Correct Sprocket Size - by Tom Smith - 01-22-2018, 01:15 PM
RE: Correct Sprocket Size - by Brian Smith - 01-22-2018, 07:25 AM
RE: Correct Sprocket Size - by steve miller - 01-22-2018, 10:38 AM
RE: Correct Sprocket Size - by Randy Dacus - 01-22-2018, 02:19 PM
RE: Correct Sprocket Size - by Tom Smith - 01-22-2018, 11:46 PM
RE: Correct Sprocket Size - by Chris Marchand - 01-22-2018, 05:52 PM
RE: Correct Sprocket Size - by steve miller - 01-22-2018, 08:38 PM
RE: Correct Sprocket Size - by Brian Smith - 01-24-2018, 07:15 AM
RE: Correct Sprocket Size - by Tom Smith - 01-25-2018, 02:37 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)