10-15-2017, 07:31 AM
(This post was last modified: 10-15-2017, 07:38 AM by tom dandes.)
(10-14-2017, 09:53 AM)Sterling Brundick Wrote:(10-14-2017, 09:46 AM)Bob LeFevre Wrote: Sterling. Not an expert but I believe that while holding it the caliper has no pressure on it so it keeps pushing out a few thousands at a time. If you mount it on the rotor it will pull back a few thousands when the petal is released. Just my observation of the airheart brakes.
Bob
It does not retract when installed. At least not enough for me to freely turn the axle.
AeroShell Fluid 41 Mineral Aircraft Hydraulic Fluid - Quart Can
Sterling if you rebuilt the caliper makes sure that the washer was installed correctly because one side has a bevel to it. It can bind if upside down. Even when it's installed right the caliper never releases fully and will always drag on the rotor. I was never happy with this on my Karts so I changed over to Enginetics. No more drag..