09-30-2017, 12:33 PM
(This post was last modified: 09-30-2017, 12:39 PM by sam bennett.)
So, here's what I know about the Lynx: Made from 1987 to 1996
The front end is 24.5" bolt to bolt.
Rear tubes are 23" from center to center.
The spindle KPI was 12* standard.
Caster could be adjusted at 12* or 18* with additional purchase.
Wheelbase is 40.5".
Left bias driver placement.
Keith had made mention there was a non A/C version of the Lynx for the long tracks or perhaps sit-up enduro.
compare to SR-16:
+ 1" longer wheelbase.
+2.5" wider in the front.
15* KPI
Center bias driver.
Thanks for reading.
The front end is 24.5" bolt to bolt.
Rear tubes are 23" from center to center.
The spindle KPI was 12* standard.
Caster could be adjusted at 12* or 18* with additional purchase.
Wheelbase is 40.5".
Left bias driver placement.
Keith had made mention there was a non A/C version of the Lynx for the long tracks or perhaps sit-up enduro.
compare to SR-16:
+ 1" longer wheelbase.
+2.5" wider in the front.
15* KPI
Center bias driver.
Thanks for reading.