Vintage Karting Forum › Main forums › General v
Vintage speed tire question

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Vintage speed tire question
Brad Rose Offline
west central Indiana
***
Posts: 123
Threads: 29
Joined: Jan 2016
Reputation: 0
Location: west central Indiana
#11
06-17-2017, 12:16 PM (This post was last modified: 06-17-2017, 04:24 PM by Brad Rose.)
Ok
11x4.5x5 on Tri star wheel without spacer.(top)
Same tire with 1 inch spacer. (Bottom)
One question. I just cut the other half of the valve stem hole out of my spacer. This offsets the valve stem from the tube inside putting a side load on the stem. Will this be a problem or should I drill the valve stem hole in the center of the spacer so the stem is in direct line of the Center of the wheel?


Attached Files Thumbnail(s)
       
Find
Reply


Messages In This Thread
Vintage speed tire question - by Brad Rose - 06-15-2017, 06:53 PM
RE: Vintage speed tire question - by Brad Rose - 06-16-2017, 08:35 AM
RE: Vintage speed tire question - by Jim Waltz - 06-16-2017, 11:44 AM
RE: Vintage speed tire question - by Brad Rose - 06-16-2017, 07:29 PM
RE: Vintage speed tire question - by Brad Rose - 06-16-2017, 07:46 PM
RE: Vintage speed tire question - by Brad Rose - 06-16-2017, 08:11 PM
RE: Vintage speed tire question - by ted johnson - 06-16-2017, 08:29 PM
RE: Vintage speed tire question - by Brad Rose - 06-16-2017, 09:15 PM
RE: Vintage speed tire question - by ted johnson - 06-17-2017, 07:21 AM
RE: Vintage speed tire question - by Brad Rose - 06-17-2017, 12:16 PM
RE: Vintage speed tire question - by ted johnson - 06-17-2017, 07:56 PM
RE: Vintage speed tire question - by steve welte - 06-18-2017, 11:04 PM
RE: Vintage speed tire question - by ted johnson - 06-19-2017, 08:35 AM
RE: Vintage speed tire question - by Brad Rose - 06-19-2017, 08:31 PM
RE: Vintage speed tire question - by ted johnson - 06-19-2017, 09:08 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)