So is what I did was placed my spacer over the bolts with the outer half of the wheel and marked on the inside of the spacer with a sharpie where the pins were. Then I took my chainsaw file and filed two notches in the spacer to clear the pins so the spacer would lay flat. Picture 3 shows this.
I hope this helps you and whomever decides to use these wheels. Take note I'm not a veteran karter so hopefully we'll get more info after this post from some of the veterans.
Also Gus at vintage speed said the sweet spot for the 11x4.5x5 is 3 1/2 to 4 1/2 inches in width.
I hope this helps you and whomever decides to use these wheels. Take note I'm not a veteran karter so hopefully we'll get more info after this post from some of the veterans.
Also Gus at vintage speed said the sweet spot for the 11x4.5x5 is 3 1/2 to 4 1/2 inches in width.