Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
1977 Margay Panther X build thread
#17
Vico, nice prototype, but how were you going to turn it into aluminum? That'd be one expensive machined part. If you decide you want the throttle cable holder like Comet sells, PM me your address and I'll send you one that's similar, but a little shorter so you use the smaller cable pull on the throttle shaft. I had a bunch of them water jet cut, but there are several left out in the shop. You get to sand the edges, but they end up nicer than the factory holders. I'm using mine on all my carbs now. Ted
Reply


Messages In This Thread
RE: 1977 Margay Panther X build thread - by ted johnson - 05-26-2017, 07:41 AM

Forum Jump:


Users browsing this thread: 3 Guest(s)