Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Need a used Westbend 580 rod
#1
Looking for a well used Westbend 580/700 connecting rod. Doesnt have to be pretty or even usable. Worn, rusty and pitted lower journal is fine. I have an idea for swapping it to a different brand bushing motor. Just need to acquire one and adjust it to confirm if actually will work. I would prefer one with little to no value so in case it doesnt work, a good part is not trashed.

For anyone curious, I am installing it in a Clinton A-490. The Westbend rod is slightly longer but... With an offset bushing on top will drop it down enough to fit. Then just scallop the piston to correct port timing. A full floating two piece bushing will also be made for the lower. A big plus is upping the compression a good bit.
Reply


Messages In This Thread
Need a used Westbend 580 rod - by Terry Bentley - 05-03-2020, 07:48 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)