05-15-2019, 04:02 PM
(This post was last modified: 01-29-2023, 11:08 AM by Mark Loraine.)
I’m looking for a single piece for a VanTech Stuffer mount which is between the carburetor and the reed cage, note this is a short version manifold, not a high rise used on intake manifolds bolted to the intake side of the block. It may or may not have ¼” studs, I’d take either.
I used one of Perry Blairs old TuckerB’s auctions for the picture here.
PM me if you have one to sell. I think the one I want is for the HL pattern Tillotson.
VanTech stuffer mount.jpg (Size: 38.17 KB / Downloads: 92)
I used one of Perry Blairs old TuckerB’s auctions for the picture here.
PM me if you have one to sell. I think the one I want is for the HL pattern Tillotson.
VanTech stuffer mount.jpg (Size: 38.17 KB / Downloads: 92)