Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
WTB Mac Mc10 or D44 saw Fan housing- FOUND ONE
#1
This is probably the last piece I need to finish my Mc10 clone.

Only came on Mc10 and D44 saw.

McCulloch P/n = 51228

Pm or email me if you have one to sell.
Damaged is OK, I can probable fix most any damage.

Scott

I am all set, Cat Kart stepped up on a tip from Stroker Ace.
Thank you for all the input,
Scott
Reply
#2
Also the model 55.
Reply
#3
(04-01-2020, 04:43 PM)Scott Kneisel Wrote: This is probably the last piece I need to finish my Mc10 clone.

Only came on Mc10 and D44 saw.

McCulloch P/n = 51228

Pm or email me if you have one to sell.
Damaged is OK, I can probable fix most any damage.

Scott
HELLO SCOTT
.
Try this 
.
.

https://www.ebay.com/itm/FLYWHEEL-SHROUD...Sw-rReTfBP
Reply
#4
That shroud on ebay fits Super 44/55 and newer models. Doesnt come quite close to the D44/55.


BUT...........

[Image: attachment.php?aid=4565]

If you like welding this magnesium its not too difficult to cut the top edge down on later model shroud and convert to a D44 style. I have done them in the past, but it is a little time consuming. Patience is required.

[Image: attachment.php?aid=4566]

This area can even be notched out to resemble the earlier shroud. It is an option.


Attached Files
.jpg   DSC04794.JPG (Size: 2.22 MB / Downloads: 135)
.jpg   DSC04795a.JPG (Size: 570.24 KB / Downloads: 131)
Reply
#5
(04-02-2020, 03:26 PM)Terry Bentley Wrote: That shroud fits Super 44/55 and newer models. Doesnt come quite close to the D44/55.


BUT...........

[Image: attachment.php?aid=4565]

If you like welding this magnesium its not too difficult to cut the top edge down on later model shroud and convert to a D44 style. I have done them in the past, but it is a little time consuming. Patience is required.

[Image: attachment.php?aid=4566]

This area can even be notched out to resemble the earlier shroud. It is an option.

Scott is correct!  Only on the D44 and Mc-10.  The same is true for the cylinder head.
Reply
#6
These are the two chainsaw models with correct head and shroud.

[Image: attachment.php?aid=4567]
[Image: attachment.php?aid=4568]


The D44 is a direct drive model using .404 chain.

[Image: attachment.php?aid=4569]

The model 55 powerhead is identical but has a governor with gear reduction transmission and uses 1/2" chain.


Attached Files
.jpg   DSC04797.JPG (Size: 2.13 MB / Downloads: 115)
.gif   44.gif (Size: 121.97 KB / Downloads: 96)
.jpg   55.jpg (Size: 26.71 KB / Downloads: 97)
Reply
#7
Got it
will keep looking
Reply
#8
I believe there is one on ebay now, but he saw you coming.
Reply
#9
Got one from Tim Hinson at Cat Kart,
Thanks for all the input.
Scott
Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)