+- Vintage Karting Forum (https://www.vintagekartforum.com)
+-- Forum: Main forums (https://www.vintagekartforum.com/forumdisplay.php?fid=1)
+--- Forum: General (https://www.vintagekartforum.com/forumdisplay.php?fid=2)
+--- Thread: Updated 12/29/23 Needed application Wiseco 1013RS L Ring (/showthread.php?tid=3286)
Updated 12/29/23 Needed application Wiseco 1013RS L Ring - Mark Loraine - 05-21-2023
SKIP TO BOTTOM POST.
Wondering if anyone has the Wiseco piston application chart for the old green envelope piston ring number 1013RS I have on-hand.
I am looking for the size of the ring primarily and engine application after.
These will be in the Foreign section.
Ultimately, I need a ring to fit a 50.10 mm Sirio piston I have for my ATK/Atomik Reed 100 cc engine.
Bore size as I recall was 50.18 mm at the top ridge.
I'd take 2 if anyone has them, but lets get the application of the above mentioned ring first please.
Thank You,
Mark L. / SWNY
RE: Needed application and size for Wiseco 1013RS L Ring - Terry Bentley - 05-21-2023
I thought it was for 50.8 bore range, but incorrect.
The 1012 part number is for the Komet pistons, not 1013.
You should have no problem collapsing that L ring and take a measurement to find out what bore range it fits.
RE: Needed application and size for Wiseco 1013RS L Ring - Mark Loraine - 09-28-2023
O K, no takers on that part number.....
How about this one? (1040 has been identified as LMR)
Wiseco 1040P and 1050P piston kits/
my old Wiseco #12 kart catalog doesn't list them, So I suspect it may be old Euro motocross dirt bike applications.
Since the number is in the 1000 series, I was hoping it was kart, but it may not be.
Thanks,
Mark /// SWNY
RE: Needed application and size for Wiseco 1013RS L Ring - Mark Loraine - 10-01-2023
(05-21-2023, 06:16 PM)Terry Bentley Wrote: I thought it was for 50.8 bore range, but incorrect.
The 1012 part number is for the Komet pistons, not 1013.
You should have no problem collapsing that L ring and take a measurement to find out what bore range it fits.
Rob Voska has identified the 1013 ring as Komet A , 50.8mm Terry.
Thanks Terry.
Mark L./SWNY
RE: Updated 10/1/23 Needed application and size for Wiseco 1013RS L Ring - Mark Loraine - 12-29-2023
bump looking to buy;
I need a L-ring to fit a 50.10 mm Sirio piston I have for my ATK/Atomik Reed 100 cc engine.
Bore size as I recall was 50.18 mm at the top ridge.
I'd take 2 if anyone has them, PM me if you can help out.
Thanks,