MAC Bolt Pattern - Printable Version +- Vintage Karting Forum (https://www.vintagekartforum.com) +-- Forum: Main forums (https://www.vintagekartforum.com/forumdisplay.php?fid=1) +--- Forum: General (https://www.vintagekartforum.com/forumdisplay.php?fid=2) +--- Thread: MAC Bolt Pattern (/showthread.php?tid=2247) |
MAC Bolt Pattern - rwmorrisiii - 05-25-2018 Hey Guys, Does anyone have the specs or a drawing that shows the 4 bolt holes relative to the crank centerline on the 100cc MAC's? I'm working my way thru a potential new mount for my Kart and I need these bolt hole dimensions. Thanks, RM RE: MAC Bolt Pattern - ted johnson - 05-26-2018 You can extract the pattern from this. We've used this hole pattern several times on different mount plates. The .245 diameter on the mount holes is deliberate. This was a drawing to have the plate water jet cut. I always undersize my holes on water jet so I can clean them up on the drill press. A good drill size is .257, or Letter "F". Ted RE: MAC Bolt Pattern - rwmorrisiii - 05-26-2018 Right On! Thanks so much. -RM |