+- Vintage Karting Forum (https://www.vintagekartforum.com)
+-- Forum: Resource Archive (https://www.vintagekartforum.com/forumdisplay.php?fid=88)
+--- Forum: Restoration Advise Section Basics to Complex (https://www.vintagekartforum.com/forumdisplay.php?fid=90)
+---- Forum: Engine Advise (https://www.vintagekartforum.com/forumdisplay.php?fid=58)
+----- Forum: Mcculloch Engines (https://www.vintagekartforum.com/forumdisplay.php?fid=59)
+----- Thread: CHT lead for Digatron DT-6E on a Mac (/showthread.php?tid=1120)
CHT lead for Digatron DT-6E on a Mac - Ryan Johnson - 02-25-2017
I'm Hi everyone, I have a DT-6E I'd like to run on a Mac and I purchased the CHT lead from Digatron p/n CH60RRF-6A and it doesn't seem to want fit below the spark plug, there's not enough room in the spark plug location of the head for the CHT thermalcouple ring. If anyone can tell me what lead I need, I'd greatly appreciate it.
Thanks,
Ryan
RE: CHT lead for Digatron DT-6E on a Mac - chuck giacobbe - 02-26-2017
i have some digatron ss-102 CHT leads on ebay. http://www.ebay.com/itm/VINTAGE-RACING-GO-KART-NOS-DIGATRON-CYLINDER-HEAD-TEMP-SENSOR-CHT-CART-PART-/381980711926?hash=item58efd31bf6:g:dTkAAOSwWxNYp2wM this is an old part number for the old style digatrons.
RE: CHT lead for Digatron DT-6E on a Mac - Ryan Johnson - 02-27-2017
Thanks Chuck, that looks like the same lead I have.
Ryan
RE: CHT lead for Digatron DT-6E on a Mac - thomas kelley - 02-28-2017
i blew a plug out of my head because of the lead thickness
either grind the lead or the head to fit..that's what steve ohara told me
tk
RE: CHT lead for Digatron DT-6E on a Mac - Ryan Johnson - 03-01-2017
(02-28-2017, 11:06 PM)thomas kelley Wrote: i blew a plug out of my head because of the lead thickness
either grind the lead or the head to fit..that's what steve ohara told me
tk
Thanks, that was pretty much the direction I was headed l just want to hear from someone else before I started grinding.
Ryan