I need the aluminum riser block that bolts to the stuffer end of the west bend 820 block then bolts to the slider mount on a sidewinder kart. Please pm me if you have one to sell.

SKIP TO BOTTOM POST.

Wondering if anyone has the Wiseco piston application chart for the old green envelope piston ring number 1013RS I have on-hand.
I am looking for the size of the ring primarily and engine application after.
These will be in the Foreign section.

Ultimately, I need a ring to fit a 50.10 mm Sirio piston I have for my ATK/Atomik Reed 100 cc engine.
Bore size as I recall was 50.18 mm at the top ridge.

I'd take 2 if anyone has them, but lets get the application of the above mentioned ring first please.

Thank You,

Mark L.  /  SWNY

Has anyone found a replacement air filter like the original "Skinner Ribbon Air Filter"? They were used on many early chainsaws, lawnmowers and kart engines in the late 50's and early 60's like the West Bend.  I have the carburetor base plate, "tower" support and the end plate.  The filter element was about 1.4" - 1.5" inches in diameter and about 2.5" inches in length.  My 580 is going on a minibike.

So far I cannot find any small air filters this size that will work.  The Skinner filter is shown below on a Homelite chainsaw that was made from '59 - '61.  Thanks!

Made up some Johnson Rings (Ted Johnson) and ran them in my 49 over the weekend. They worked very well. Saw piston with stock 1/16" rings cut down to .030 face.

For sale Mc. 101 cylinder sleeves. $125.00 each plus shipping. P.M. with any questions.

Looking for a piston for a Mac 7-91 that is 0.065" oversize, Can be any configuration

Measures at least 2.225" at the skirt

Email or call or PM if you have something close to that.
Scott

I am working on an MC-91A engine that has been sitting on a shelf for many years, at least 6 but probably longer. Looking thru the exhaust port, the cylinder looks really good and the engine has good compression. From the research I have done, a major concern about using an engine that has been sitting is that the bearings on the piston pin could be stuck. Is there any way to ensure they are free or to free them up short of removing the piston and replacing the bearings. Any suggestions would be greatly appreciated.

Thanks,

Michael

Hi;

Does anyone here know a Troy Marcus from the Texas area?  I ordered some parts from him and he seems to have fallen off the map.

Thanks;
Bob Alexander

Looking for a 5" rear outer wheel half for a GK1200 for a fellow karter. Picture attached.

Thanks,

Michael


  IMG_2920.jpg (Size: 721.9 KB / Downloads: 19)

I am trying to help a fellow karter put a GK1200 kart together. When he acquired it, it had a broken direct drive dyna-drive gearbox. He wants to put a conventional sprocket and chain on it. However there is no engine mount on it. Does anyone have a picture of what the engine mount looks like or have an extra mount? I attached a picture of what the rear of the kart currently looks like.

Thanks,

Michael


  IMG_2918.jpg (Size: 667.08 KB / Downloads: 14)